QUICK tile adhesive BOSTIK MC240 C2FG gray

• Ideal hypermarkets, U4P4S premises at most
• New work and renovation without primer on old tiling
• Simple gluing: quick installation/time saving

DESTINATIONS

One-component C2 FG quick-drying fluid adhesive mortar - U4P4/U4P4S approved - intended for laying ceramic coverings and natural stone of all porosity and large formats (up to 3600 cm²)

• Interior/exterior floors
• Bonding on old tiles (with primer Primasol R ) and old semi-rigid plastic tiles
• Simple gluing up to 3600 cm²
• Grouting 2 to 3 hours after gluing the tiles.
• Ideal for commercial premises and large tiled areas

IMPLEMENTATION

Substrate preparation :

• Refer to the CPT and DTU 52.2 in force. New substrates must be clean, dry, sound, solid, surfaces free of grease, laitance, traces of plaster, etc. They must be aged:
  • 1 month for concrete slabs
  • 2 months for concrete walls and floors
  • 15 days for cement screeds
  • 48 hours for indoor cementitious coatings
  • 3 weeks for exterior cement coatings
• On calcium sulphate screed, apply our primer PRIMASOL R at saturation.
• The renovation supports will be prepared in accordance with the CPT renovation in force.
• On wooden support (panels or old mosaic parquet), apply our primer PRIMABOIS in a dry room before the implementation of Ardasol 3 fiber Or E 100 XP in a damp room.
• On old tiling, sand and dust off apply direct bonding with MC 240 Fluid & Express
• On old semi-flexible slabs, strip and rinse then apply our primer PRIMASOL R before laying tiles with MC 240 Fluid & Express .

Preparation of the mixture

• Pour into a clean bucket 4.5 l to 5 l of water per 25 kg bag.
• Introduce the powder into the water and mix with an electric mixer equipped with a suitable whisk until a smooth and homogeneous paste is obtained.
• Leave to stand for a few minutes then remix before application

Application

• Spread the mortar-adhesive on the support with the smooth side of the spatula then adjust the thickness of the furrows with the notched side.
• Do not apply too much surface and beat the tiles well in order to obtain an optimal transfer.
• Eliminate residues of MC 240 Fluid & Express on the tiles or between the joints with a damp sponge as the installation progresses.
• After drying the MC 240 Fluid & Express (3 hours minimum), grouting will be carried out with one of the following products:
  • J 100 End Seal (width from 1 to 6 mm)
  • J 125 Wide Gasket (width from 3 to 20 mm)
  • J 150 Gasket Rustic (width from 5 to 80 mm)
  • J 175 Joint Flex (width from 2 to 15 mm)
  • J 200 HRC seal (width from 2 to 15 mm)
  • J 300 Epocolor (width from 2 to 15 mm)

Consumption